EQ-3 MAX! Cube Manuel d'utilisateur télécharger pdf (Page 18)

• Use the screws and plugs supplied to fasten the bracket

to the wall.

• Once the wall bracket is in place,

the MAX! Cube can be attached to

the wall bracket from above, with

the opening pointing down.

6. Setting up the MAX! system

System set-up involves the following steps, which are de-

scribed below:

• Connecting the MAX! cube

• Installing the MAX! software

• Installing and teaching in the MAX! devices

• Setting up Internet control

6.1 Connecting the MAX! cube

1. Connect the MAX! cube to the power supply:

The MAX! cube draws its power supply from the plug-in

main adapter included in the scope of supply.

Attention: To avoid damaging the device, please

only use the original main adapter supplied with the

device for the power supply.

• Plug the USB main adapter supplied into a socket outlet.

• Connect the MAX! cube and the main adapter with the

USB cable. Use the USB port on the side of the device

(2) for this purpose (see diagram on page 16).

• The power LED starts to ash as soon as the MAX! cube

initiates a self-test.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Pas de commentaire

EQ-3 MAX! Cube Manuel d'utilisateur Page 18